Loading... Please wait...
- Home
- Products
- New
- Blog
- Wiki
- Shipping
- Newsletter
- Contact
-
Tech FAQ
- Connect AIR3 to TBS Crossfire Rx
- How to use FC LiPo Voltage for AIR3 iNav OSD
- How to re-flash AIR3 iNAV bootloader
- Calibrating RC Transmitter Tx - for PARIS AIR3 iNav BetaFlight
- FrSky R-XSR Firmware Update Proceedure
- Knife 200/240 - building guide
- tricopter build guide Scarab 660
- Scarab QuadOcta building guide
- Failsafe RC setup - What is the best way to set up failsafe for a Naze Quad
- My ESCs are hot - Why is only one red wire required for 5v ESC BECs connected in parallel
- My Quad copter with Naze / AIR Hero•32 is twitching
- how do I trim my PARIS Sirius™ Air HERO•32 miniQuad Controller naze board BaseFlight
- Which FrSky Rx receivers does the Taranis (with X9D internal module) support
- What is the best FPV Tx for a beginner
- Scarab Knife - Seperate BEC needed to run off opto 18A ESC
- How do i use Ch9 Sbus on Taranis X8R / PARIS v5r3 Mega to control camera tilt on my servo gimbal pin 44
- My Quad - with Hero v2 is tail wagging - how to fix
- Quad motor suddenly stopped/stuttered - my Quad flipped - was ok before
- How can I get my Taranis X8R to use S-Bus 1-8 and other pins 9-16 for camera gimble tilt, roll and shutter
- How do i reverse a MultiWii Tricopter tail servo direction Air v2
- What is the difference between a Quad Flipping vs a Quad Flopping down
We are back from our break !! We have recommenced shipping. Apologies for any inconvenience.-->
|
|
|