Loading... Please wait...
Click the image above to see a larger version
  • Image 1
  • Image 2

Power Distribution board - Voltair - Fully Assembled - XT 60 Amp 8+2 Way

Shipping Weight:
115.00 Grams
Stock Remaining:

Product Description

Fully assembled version of VoltAir® is our new XT60 x 8 - a 60 amp power distribution board (72amps for 15 secs)  we manufacture for single LiPo Octas 4S->6S -  a small 50mmx50mm PCB  - which makes it very easy to wire together up to 4 ESCs and addition power outlets for FPV and LEDs.   for larger 5kg class Quads and HexiiCopters needing up to 6 x XT60 power outlets - Plug n Play for our 40Amp ESC HERE


Hero Features

  • Fully assembled 8 Way XT60 + 2 x JST 5 amp - as shown with mounting hardware included (see below)
  • Connects directly to our ESCs in our store - HobbyWing 40Amp ESCs
  • Rated and tested to 60 amps continuous - tested to 72amps for 15 secs - realistically if you are running 6S you should be able to fly at 8Kg and below 60amps ; but I would advise using the 200amp version if close to 60 amps in the hover, mainly so you can run at least 2 LiPos or 4 LiPos not one.
  • tiny product 50x50mm - with standard 45mm hole centres  - (measured square axis across)  - 1.6mm RoHS gold plated PCB
  • Super thick 140um copper rings joined by 192 vias - so both sides of the board act together to conduct large amounts of current
  • Plated holes for strength and 100% power delivery
  • 8 sets of XT60 connectors for 8 ESC
  • 1 thin wire +ve lead 150mm for ANDROMEDA LED board
  • 4 x M3 mounting holes -  unplated -  to isolate 
  • 94g item weight


  • 1 x fully assembled Voltair® board - 8 x XT60 and also 2 x JST outlets - as per photo
  • 4 x 6mm nylon stand-offs
  • 4 x M3 nuts nylon
  • 4 x M3 6mm nylon bolts



  • Excludes Deans -> XT60 convertor plug if required
  •  WARNING - Requires insulation from carbon frame - use the supplied  nylon stand offs and nylon bolts and nuts insulation tape after completion - do NOT bolt down directly onto Carbon plates (carbon conducts electricity
  • LiPo batteries are safe if handled correctly - if mis-handled LiPo Batteries will catch fire and burn at 700°C - Dont take risks with cheap chargers or short circuits
    1. Use of a fire resistant bag/container for LiPos - fully Fibreglass lined - not a fake
    2. Use a know/proven top brand charger limited to 4.2v per cell - calibrated - see Gearlist page
    3. Use all balance ports to monitor 4.2v per cell during charge
    4. Use of thermal protection - temp sensor attached on each lipo for cut-off of all power if the charge temp rises about 45°C
    5. Store LiPos at 3.8v per cell

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Currency conversion