Loading... Please wait...
Click the image above to see a larger version
  • High RPM HQ Prop Set 8"x5 CW/CCW - 1 pair AU NZ
  • Image 2
  • Image 3

High RPM HQ Prop Set 8"x5 CW/CCW - 1 pair

Shipping Weight:
65.00 Grams
Stock Remaining:

Product Description

These are the new HQ Prop 8 x 5 high RPM props (31 Aug 2013) -  a matching set of 1 x CW(R) and 1 x CCW(standard) low pitched multicopter props.  These are specifically matched to 1175kv CarbonBird motors on 4S 16.8v. We have tested them to 12,500 RPM and amazingly -  They require almost NO balancing - They are tough and quite.  they are amazingly similar to the Graupner E-Props in that they have a strong centre airflow and good motor cooling.


  1. Quiet - suitable for indoor or urban Ops
  2. Strong ABS plastic with carbon fibres in the plastic - black carbon composite
  3. Super light weight 7.6grams - perfect for rapid speed changes - required to stabilise multiwiicopters
  4. Suits 1175kv - 4S - CarbonBird®
  5. 5mm ID  - 6MM/8MM/9.5MM staggered inside tapers - (requires a prop REAMER - NOT included) - comes with 3MM,4MM,5MM,6MM adapter rings.
  6. Requires 7.5mm shaft height ; 5mm diameter shaft to mount it.
  7. These are high quality props for a great low price - made by HQ Prop - have passed all our MultiWiicopter tests - but you must adhere to safety warnings about props below - always.
  8. require almost NO balancing (always check every prop and use 800 grit wet-n-dry to remove any sharp edges at the leading edge of the blades)


  • 2 props as you see in Photo 1 at right - 1 CW(R) and 1 CCW 8"x5   with 5mm bore


Balancing - These HQProps are near perfect as supplied (true) - they require almost no balancing - However you must check each and every prop yourself - BEFORE FLYING - on a balancer 
Limitations - Do not exceed the max RPM 12.500 - replace any prop if damaged or crashed - You must understand the risk of flying a Quad with a damaged prop can result in the Multicopter crashing/falling and hurting a 3rd party or yourself - YOU WILL BE RESPONSIBLE for this !  - props can cut - keep away from eyes!  wear safety glasses ALWAYS !
•Keep your PROPS OFF - not installed - until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures -  realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static -  PROPS may start at anytime without warning.  Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe.  PROPS can CUT ! take precautions !  Never fly closer than 30m to/from any person or pet
Question - Can it use this prop on dji motors - ?
As supplied - NO - You must first purchase a prop reamer from this site and bore out to 8mm to use with dji motors

Write your own product review

Product Reviews

  1. Perfect Fit

    Posted by Jamie Ackland on 24th Jul 2016

    these were brought for my Scarab Armour - to go with my new Motors. these props are of high quality and well balanced out of packet. perfect for my smaller 3s powered Quad - and will be also good for 4s when i make the switch! recommended

Currency conversion