Loading... Please wait...
- Home
- Products
- New
- Blog
- Wiki
- Shipping
- Newsletter
- Contact
-
Tech FAQ
- Connect AIR3 to TBS Crossfire Rx
- How to use FC LiPo Voltage for AIR3 iNav OSD
- How to re-flash AIR3 iNAV bootloader
- Calibrating RC Transmitter Tx - for PARIS AIR3 iNav BetaFlight
- FrSky R-XSR Firmware Update Proceedure
- Knife 200/240 - building guide
- tricopter build guide Scarab 660
- Scarab QuadOcta building guide
- Failsafe RC setup - What is the best way to set up failsafe for a Naze Quad
- My ESCs are hot - Why is only one red wire required for 5v ESC BECs connected in parallel
- My Quad copter with Naze / AIR Hero•32 is twitching
- how do I trim my PARIS Sirius™ Air HERO•32 miniQuad Controller naze board BaseFlight
- Which FrSky Rx receivers does the Taranis (with X9D internal module) support
- What is the best FPV Tx for a beginner
- Scarab Knife - Seperate BEC needed to run off opto 18A ESC
- How do i use Ch9 Sbus on Taranis X8R / PARIS v5r3 Mega to control camera tilt on my servo gimbal pin 44
- My Quad - with Hero v2 is tail wagging - how to fix
- Quad motor suddenly stopped/stuttered - my Quad flipped - was ok before
- How can I get my Taranis X8R to use S-Bus 1-8 and other pins 9-16 for camera gimble tilt, roll and shutter
- How do i reverse a MultiWii Tricopter tail servo direction Air v2
- What is the difference between a Quad Flipping vs a Quad Flopping down
|
|
|
- Home
- Wires & Misc
- Wires - 1.25 Molex PARIS Sirius™ - 4 Pin->5 Pin LV 75mm
Product Description
These 1.25mm molex plugs 32 AWG Wires for PARIS Sirius™ owners to update to the V4r6 or repair of a PARIS board (if you got involved in a high speed encounter with an FPV obstacle course) - the empty pin aways you to connect to a HV socket and only draw 3v3.
Features very strong multistrand core - wires with professional applied molex connectors
Includes
One pre-made Molex 4 pin plug with 4 wires - 75mm -> 5Pins plug - as per photo - for LV (3.3v) connections only (the 5th pin is empty)
Requires/Excludes
Requires careful checking of pins orientation - Do not force pins backwards ! Reversed connection = Permanent damage can occur to PARIS and Sensors !!!!
NOTE : Never pull on the wires with guerrilla force - grip the plug and rock gently side-to-side ; to install always brace the back of the female - to ensure the male does not break the female while mounting.
