The v3 mini-Andromeda 50 is a multi function CORE PDB made by Carbonbird and includes everything a mini Quad  needs to keep the build clean, compact and reliable - even the LEDs are installed and brighter than anything else on the market for FPV

Features of the mini-Andromeda 50 PDB

• 8 Ultrabright LEDs (4 Blue front) and (4 x Red Rear) these can be seen at 300m in full Aussie sunlight
• 12v regulated power for FPV camera/Tx 500ma
• 5v regulated power for Flight controller 5v / 4.5v 500ma
• 4s 16.8v input
• 50 AMP PDB continuous
• LEDs and PDB consume 1.8w @16v (110ma)
• Only 17grams with XT60
• Fits the standard 30.5mm square hole spacing used in all FPV drones 
• has 8 lead out points to distribute power to 4 x ESC
• Designed for HS1177 12v PV camera support
• Designed for 200mw class FPV Tx (350ma nominal power draw via 12v BEC onboard)
• Nominal power drawn WITH HS1177 camera and 200mwTx combined and LEDs = 5.8w/[email protected] 4s or = 4.1w/[email protected] 3s
• Nominal power draw without FPV camera or Tx = 1.8w/[email protected] (LEDs only)
• dimensions 56x38mm (12mm h without xT60)

Includes

• 1 x mini-Andromeda 50 board  - ready to run on 3S or 4S
• 1 x XT60 connector
• 1 x XT30 

Excludes

• Excludes Wires  specific to HS1177 and 200mw Tx - SOLD HERE or special long versions for bigger quads HERE 
• Excludes FrSky A2 sensing wire HERE
• Excludes 1177 camera sold here
• Excludes 200mw Video Tx sold Here
• Excludes / Requires soldering skills 
• Excludes nylon 6mm standoffs here or select any other size or colour here 

Andromeda Connection 

• When soldering the XT60 or XT30 connectors be sure to use a LARGE 125w soldering iron so the join can be made in 2 secs - WARNING - using a small 60 or 90w electronics solder tip will take too long and will not be able to create a good joint - a dry solder joint will result in power failure and a crash - RISK - you must use Amtech 223 flux and make solid / rapid soldering joins
• its is vital NOT to connect other devices to the 5.0v or 4.5v ports - this power is exclusively reserved for the FLIGHT CONTROLLER
• it is vital NOT to short the base of the PDB onto CARBON ! - Danger - Carbon is fully conductive and shorts of lithium batteries may cause fire /harm /smoke
• XT60 connectors must be sized (insert a 1.5 tool) so the blades are well spread out - if the XT60 probes are compressed they will not make firm contact with the female on the LiPo battery - lubricate the XT60 with lanolin spray