Loading... Please wait...
- Home
- Products
- New
- Blog
- Wiki
- Shipping
- Newsletter
- Contact
-
Tech FAQ
- Connect AIR3 to TBS Crossfire Rx
- How to use FC LiPo Voltage for AIR3 iNav OSD
- How to re-flash AIR3 iNAV bootloader
- Calibrating RC Transmitter Tx - for PARIS AIR3 iNav BetaFlight
- FrSky R-XSR Firmware Update Proceedure
- Knife 200/240 - building guide
- tricopter build guide Scarab 660
- Scarab QuadOcta building guide
- Failsafe RC setup - What is the best way to set up failsafe for a Naze Quad
- My ESCs are hot - Why is only one red wire required for 5v ESC BECs connected in parallel
- My Quad copter with Naze / AIR Hero•32 is twitching
- how do I trim my PARIS Sirius™ Air HERO•32 miniQuad Controller naze board BaseFlight
- Which FrSky Rx receivers does the Taranis (with X9D internal module) support
- What is the best FPV Tx for a beginner
- Scarab Knife - Seperate BEC needed to run off opto 18A ESC
- How do i use Ch9 Sbus on Taranis X8R / PARIS v5r3 Mega to control camera tilt on my servo gimbal pin 44
- My Quad - with Hero v2 is tail wagging - how to fix
- Quad motor suddenly stopped/stuttered - my Quad flipped - was ok before
- How can I get my Taranis X8R to use S-Bus 1-8 and other pins 9-16 for camera gimble tilt, roll and shutter
- How do i reverse a MultiWii Tricopter tail servo direction Air v2
- What is the difference between a Quad Flipping vs a Quad Flopping down
Hi everyone we are taking a break from 15 Jun 19 until 01 Aug 19. Shipping will be on priortiy of order and Class once we return. Thanks.
Upon our return we will have some new Flight Controllers for Multirotor and Fixed Wing available. These will be from our new partners, HGLRC.
Thanks to all our valued existing and new customers.-->
|
|
|
- Home
- Nuts & Bolts
- M3x6 Titanium Bolt Aircraft grade - hex head 6mm shaft - SET of 10 Scarab Knife
Product Description
Set of 10 x Titanium T2 metric M3 HEX button head bolts for your drone - Ti is 5 time stronger than stainless steel yet half the weight - does NOT rust like tool steel. Its very hard to reduce weight in aircraft - and Ti is the solution. For example a Scarab Knife has 36 M3 screws so the weight saving would be 18g (the weight of a Red 2400 motor) and yet these screws are much stronger than SS. 
Features
- UAV Aircraft grade Titanium gr2 bolt
- Ultra light weight
- hex 2mm screwdriver (hex head)
- 3mm OD metric threaded
- 6mm depth ; 5.5mm head OD
- Only 0.22g each
Includes
Includes 10 pieces* M3*6mm metric bolts
Excludes
Excludes M3 nuts (these are no required for scarab Knife)
excludes 2.0mm tool here
Note
Safe to use Blue Loctite® ; safe to use in beach or ocean side environments
