Loading... Please wait...
- Home
- Products
- New
- Blog
- Wiki
- Shipping
- Newsletter
- Contact
-
Tech FAQ
- Connect AIR3 to TBS Crossfire Rx
- How to use FC LiPo Voltage for AIR3 iNav OSD
- How to re-flash AIR3 iNAV bootloader
- Calibrating RC Transmitter Tx - for PARIS AIR3 iNav BetaFlight
- FrSky R-XSR Firmware Update Proceedure
- Knife 200/240 - building guide
- tricopter build guide Scarab 660
- Scarab QuadOcta building guide
- Failsafe RC setup - What is the best way to set up failsafe for a Naze Quad
- My ESCs are hot - Why is only one red wire required for 5v ESC BECs connected in parallel
- My Quad copter with Naze / AIR Hero•32 is twitching
- how do I trim my PARIS Sirius™ Air HERO•32 miniQuad Controller naze board BaseFlight
- Which FrSky Rx receivers does the Taranis (with X9D internal module) support
- What is the best FPV Tx for a beginner
- Scarab Knife - Seperate BEC needed to run off opto 18A ESC
- How do i use Ch9 Sbus on Taranis X8R / PARIS v5r3 Mega to control camera tilt on my servo gimbal pin 44
- My Quad - with Hero v2 is tail wagging - how to fix
- Quad motor suddenly stopped/stuttered - my Quad flipped - was ok before
- How can I get my Taranis X8R to use S-Bus 1-8 and other pins 9-16 for camera gimble tilt, roll and shutter
- How do i reverse a MultiWii Tricopter tail servo direction Air v2
- What is the difference between a Quad Flipping vs a Quad Flopping down
Hi everyone, We have had a busy holiday period moving the stock to new premises. Thanks.
We now have some new Flight Controllers for Multirotor and Fixed Wing available. These will be from our new partners, HGLRC.
Thanks to all our valued existing and new customers.-->
|
|
|
- Home
- Nuts & Bolts
- M3 Stainless steel NUTs - SET of 10 - ID 3mm - OD 6x2.5mm SS
Product Description
An SS Stainless Steel set of (10) metric M3 HEX nuts for your UAV flight control boards. Having built a number of MultiWiiCopters ourselves we find that the basic black mild steel nuts rust ... so we stock these as a service to fussy bastards like us who like shiny bling . Build them light!
Features
- Aircraft grade SS nut
- 6mm OD Hex spanner / wrench
- 3mm ID metric threaded
- 2.5mm depth
Note
Safe to use Blue Loctite®
