Loading... Please wait...
- Home
- Products
- New
- Blog
- Wiki
- Shipping
- Newsletter
- Contact
-
Tech FAQ
- Connect AIR3 to TBS Crossfire Rx
- How to use FC LiPo Voltage for AIR3 iNav OSD
- How to re-flash AIR3 iNAV bootloader
- Calibrating RC Transmitter Tx - for PARIS AIR3 iNav BetaFlight
- FrSky R-XSR Firmware Update Proceedure
- Knife 200/240 - building guide
- tricopter build guide Scarab 660
- Scarab QuadOcta building guide
- Failsafe RC setup - What is the best way to set up failsafe for a Naze Quad
- My ESCs are hot - Why is only one red wire required for 5v ESC BECs connected in parallel
- My Quad copter with Naze / AIR Hero•32 is twitching
- how do I trim my PARIS Sirius™ Air HERO•32 miniQuad Controller naze board BaseFlight
- Which FrSky Rx receivers does the Taranis (with X9D internal module) support
- What is the best FPV Tx for a beginner
- Scarab Knife - Seperate BEC needed to run off opto 18A ESC
- How do i use Ch9 Sbus on Taranis X8R / PARIS v5r3 Mega to control camera tilt on my servo gimbal pin 44
- My Quad - with Hero v2 is tail wagging - how to fix
- Quad motor suddenly stopped/stuttered - my Quad flipped - was ok before
- How can I get my Taranis X8R to use S-Bus 1-8 and other pins 9-16 for camera gimble tilt, roll and shutter
- How do i reverse a MultiWii Tricopter tail servo direction Air v2
- What is the difference between a Quad Flipping vs a Quad Flopping down
Hi everyone we are taking a break from 15 Jun 19 until 01 Aug 19. Shipping will be on priortiy of order and Class once we return. Thanks.
Upon our return we will have some new Flight Controllers for Multirotor and Fixed Wing available. These will be from our new partners, HGLRC.
Thanks to all our valued existing and new customers.-->
|
|
|
- Home
- Nuts & Bolts
- M3 Hex Standoff - 6mm Nylon White - Set of 5
Product Description
A male/female metric M3 HEX standoff to separate your UAV flight control boards by 6mm. Australia AU stock. Having built a number of MultiCopters ourselves we find the 6mm is the perfect height for a raised deck - allowing the board to clear the pins on the bottom surface of the Control board, and still let the wires run underneath un-restricted
Features
- Allows the board to clear the pins on the bottom surface
- Allows wires to run back underneath freely
- Electric insulator - will not short your board and fry your CPU/sensors
- Male/Female
- Aircraft grade Nylon
- 5mm Hex spanner
- 3mm metric threaded male and female
- 6mm shaft / 5mm bore depth
- Only 0.18g
- Protects your board by creating a fail-point in a direct impact crash (nylon Hex will break and not crack your CPU board)
Includes
- 5 x Nylon 6mm stand-off only - white
Excludes
Excludes nuts or bolts
Note
Do not tighten with a wrench - safe to use Blue Loctite®
