Loading... Please wait...
- Home
- Products
- New
- Blog
- Wiki
- Shipping
- Newsletter
- Contact
-
Tech FAQ
- Connect AIR3 to TBS Crossfire Rx
- How to use FC LiPo Voltage for AIR3 iNav OSD
- How to re-flash AIR3 iNAV bootloader
- Calibrating RC Transmitter Tx - for PARIS AIR3 iNav BetaFlight
- FrSky R-XSR Firmware Update Proceedure
- Knife 200/240 - building guide
- tricopter build guide Scarab 660
- Scarab QuadOcta building guide
- Failsafe RC setup - What is the best way to set up failsafe for a Naze Quad
- My ESCs are hot - Why is only one red wire required for 5v ESC BECs connected in parallel
- My Quad copter with Naze / AIR Hero•32 is twitching
- how do I trim my PARIS Sirius™ Air HERO•32 miniQuad Controller naze board BaseFlight
- Which FrSky Rx receivers does the Taranis (with X9D internal module) support
- What is the best FPV Tx for a beginner
- Scarab Knife - Seperate BEC needed to run off opto 18A ESC
- How do i use Ch9 Sbus on Taranis X8R / PARIS v5r3 Mega to control camera tilt on my servo gimbal pin 44
- My Quad - with Hero v2 is tail wagging - how to fix
- Quad motor suddenly stopped/stuttered - my Quad flipped - was ok before
- How can I get my Taranis X8R to use S-Bus 1-8 and other pins 9-16 for camera gimble tilt, roll and shutter
- How do i reverse a MultiWii Tricopter tail servo direction Air v2
- What is the difference between a Quad Flipping vs a Quad Flopping down
Hi everyone we are taking a break from 15 Jun 19 until 01 Aug 19. Shipping will be on priortiy of order and Class once we return. Thanks.
Upon our return we will have some new Flight Controllers for Multirotor and Fixed Wing available. These will be from our new partners, HGLRC.
Thanks to all our valued existing and new customers.-->
|
|
|
Product Description
This is the Futaba S-Bus Decoder SBD-1 - 200mm - this device is programable to access the channel not used by the WookM or Naza - Ch7->Ch16 - and allows you to connect regualr RC inputs such as the controller for a Gimbal ; the camera servo or other RC actualted devices using the spare switches and channels on your Futaba 8FG or 18MZ
Features
- 3 port conventional RC system output
- 1 port S-Bus input with 200mm lead
- Full Owners Futaba S-bus Decoder SBD-1 Manual here
Includes
1 x Futaba S-Bus decoder and 600mm with extension line
Download Futaba SBD-1 software here (used with the CUI ) see CUI page for details this site
Requires
The SBC-1 channel changer to set the output for each of the three output leads
