Loading... Please wait...
- Home
- Products
- New
- Blog
- Wiki
- Shipping
- Newsletter
- Contact
-
Tech FAQ
- Connect AIR3 to TBS Crossfire Rx
- How to use FC LiPo Voltage for AIR3 iNav OSD
- How to re-flash AIR3 iNAV bootloader
- Calibrating RC Transmitter Tx - for PARIS AIR3 iNav BetaFlight
- FrSky R-XSR Firmware Update Proceedure
- Knife 200/240 - building guide
- tricopter build guide Scarab 660
- Scarab QuadOcta building guide
- Failsafe RC setup - What is the best way to set up failsafe for a Naze Quad
- My ESCs are hot - Why is only one red wire required for 5v ESC BECs connected in parallel
- My Quad copter with Naze / AIR Hero•32 is twitching
- how do I trim my PARIS Sirius™ Air HERO•32 miniQuad Controller naze board BaseFlight
- Which FrSky Rx receivers does the Taranis (with X9D internal module) support
- What is the best FPV Tx for a beginner
- Scarab Knife - Seperate BEC needed to run off opto 18A ESC
- How do i use Ch9 Sbus on Taranis X8R / PARIS v5r3 Mega to control camera tilt on my servo gimbal pin 44
- My Quad - with Hero v2 is tail wagging - how to fix
- Quad motor suddenly stopped/stuttered - my Quad flipped - was ok before
- How can I get my Taranis X8R to use S-Bus 1-8 and other pins 9-16 for camera gimble tilt, roll and shutter
- How do i reverse a MultiWii Tricopter tail servo direction Air v2
- What is the difference between a Quad Flipping vs a Quad Flopping down
Hi everyone we are taking a break from 15 Jun 19 until 01 Aug 19. Shipping will be on priortiy of order and Class once we return. Thanks.
Upon our return we will have some new Flight Controllers for Multirotor and Fixed Wing available. These will be from our new partners, HGLRC.
Thanks to all our valued existing and new customers.-->
|
|
|
- Home
- Chargers & Power
- FrSky MLVSS LiPo cell monitor - SMART SPort
Product Description
Frsky MLVSS - Your Taranis can display and monitor the voltages of ALL cells in your LiPo battery - FrSky shrunk down the FLVSS by removing the oLED
FrSky Lipo Cell-by-Cell Voltage Sensor used in conjunction with the FrSky Taranis and a X8R Rx (or X4R) as an add-on sensor to monitor your battery cell-by-cell and total voltage also.
the default sensor ID = 2
Specs
Model: MLVSS SmartPort version
Dimensions: 43x19x8mm
Weight: 2.8g
Measurement range: 1~6S lipoly
Cell voltage display range: 0.20~4.20V
Voltage display resolution: 0.01V
Voltage detection precision: 0.05V
Current of the board: 15.5mA
Operating temperature range: -30°C~70°C
