Loading... Please wait...
Click the image above to see a larger version
  • Image 1

Bsi Foam-Cure Wing Glue - Flexible - For EPO EPS or Depron

Shipping Weight:
155.00 Grams
Stock Remaining:

Product Description

Bsi FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foam wings and parts being glued to foam like carbon rods. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.

FOAM-CURE™ works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE™ does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE™ requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.

Suitable for RC FPV wings & Carbon Spar inserts

  • Suits EPO foam
  • Suits EPS Foam
  • Suits EPP foam
  • Suit Depron Foam



! x Bottle of 120ml Foam-Cure Glue 


Directions for Use

Cut off tip of nozzle. Apply to one part before joining. Use tape to hold parts in place during cure. For faster curing, pull the joint apart and let Foam-Cure™ air dry for 5-10 min before rejoining the parts. This results in enough tack strength to allow the next steps of assembly. Full cure takes 10-12 hours. Foam-Cure™ works on all foams, especially on EPP and EPO, and will bond a porous surface to non-porous materials. Foam-Cure™ is also an excellent glue for clear canopies, and will also bond paper. If needed, denatured alcohol can be used to thin or clean up uncured Foam-Cure™. Replace cap after use.

Safety Data Sheet  - Please download the Material safety data sheet here


Precautionary Statements Prevention: Flammable vapour - Keep away from heat, sparks, open flames. No smoking. Avoid breathing vapors. Wash thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear protective gloves, eye protection and face protection. Response: IF ON SKIN: Wash with soap and water. Prolonged contact may cause dermatitis. . IF INHALED: Remove person to fresh air and keep comfortable for breathing. IF IN EYES: Rinse with water for several minutes. If eye irritation persists: Get medical attention. In case of fire: Use foam, dry chemical or carbon dioxide to extinguish. IF INGESTED: Do not induce vomiting. Drink water/milk. Get immediate medical aid. Storage: Store in a well-ventilated place. Keep container tightly closed. Keep in a cool and dark area. Disposal: Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Currency conversion